Installation Instructions
P-100 PUTTER
HEADS
1
CUT SHAFT
at 5.625” HEIGHT (not length – measure height at resting lie angle)
2
ABRADE SHAFT
0.625” of trimmed section
3
CLEAN ABRADED SHAFT TIP
(acetone recommended)
4
ABRADE INSIDE
of Putter Hosel Adapter
5
CLEAN INSIDE
(cotton swab and acetone recommended)
6
APPLY EPOXY
to shaft tip and inside of adapter
7
MUST INSTALL ADAPTER ONTO SHAFT
with indicator line parallel to the putter face
8
WIPE EXCESS EPOXY
9
ALLOW EPOXY TO FULLY
cure before handling again
SHAFTS
Must reference previously built head w/ p-100
1
CUT SHAFT
at 5.625” HEIGHT (not length – measure height at resting lie angle)
2
ABRADE SHAFT
0.625” of trimmed section
3
CLEAN ABRADED SHAFT TIP
(acetone recommended)
4
ABRADE INSIDE
of Putter Hosel Adapter
5
CLEAN INSIDE
(cotton swab and acetone recommended)
6
APPLY EPOXY
to shaft tip and inside of adapter
7
MUST INSTALL ADAPTER ONTO SHAFT
with indicator line parallel to the putter face
8
WIPE EXCESS EPOXY
9
ALLOW EPOXY TO FULLY
cure before handling again